Dante Network Audio
DANTE Enabled Musicians' Monitoring & Microphone Amplifier
Our Symphony musicians' audio monitoring and microphone amplifier was originally designed to meet one of our customers requirements. They had been using a similar analogue monitoring system for many years and when they updated their production mixer to a Dante enabled desk they naturally wanted to encompass and embrace the advantages of the network audio system to include their monitoring and musical instrument pre amplifiers.
Dante / AES67 compatibleMonitoring for 2 musicians2 x high spec microphone amplifiersMounts on a microphone standPlain rear view facing audience3 x stereo monitoring inputs2 x local instrument monitoring circuitsIndividual headphone volume controls for each musicianOriginally designed for an OrchestraTalkback mic on front panelPush To Talk (PTT) switchLCD display for setup of gains etcDisplay & setup controls on floor facing side to prevent use by musicians
32 x 32 Fixed ratio mixer with compressors
The Glensound BEATRICE MIX32 is a high density audio mixer for producing fixed ratio audio mixes from/ to DanteTM and AES67 audio networks. It can be fitted with a maximum of 4 independent mixer cards, each with their own redundant network interface. Each of these mixer cards provides 32 audio inputs and 32 audio outputs from the network, with the 32 outputs being mixes derived from different sets of input channels.
Up to 4 off 32 x 32 fixed ratio mixers in 1RUDante/ AES67 Limiter/ Compressors on Inputs (can be turned off)Limiter/ Compressors on Outputs (can be turned off)Redundant network interfaceCopper & Fibre network interfaceRedundant Power SupplyOriginaly designed for setting up intercom mixes
Dante Audio Network 4 Input, 4 Output Analogue Break Out Box
The AoIP44 is an economical sub rack designed to interface balanced analogue audio circuits to and from a Network audio system featuring Dante.
It provides 4 audio inputs to the network and also 4 audio outputs from the network on balanced 3 pin XLRs.
Simple economical Audio Over IP (AoIP) interface featuring Dante4 balanced audio inputs to the network4 balanced audio outputs from the network19" 1RU sub rackSub rack can be mounted with audio/ mains/ network connectors at the front or rear of the sub rackHigh quality audio circuits (designed for Broadcast)Internal switch mode mains power supplyBack up DC power supply optionSingle Cat5 copper interface on Neutrik Ethercon
DANTE AES67 Three Commentators Box
Paradiso is a commentators box for 3 commentators. It can be used by itself to provide the commentary facilities alongside an OB truck for small events or multiple Paradisos can be used at large events that require Worldwide broadcast coverage.
The Paradiso has been designed to be intuitive & easy to use for Commentators’ who would rather be talking about the game than working out how the equipment works, and is also built to our exacting rugged & robust standard to make it a reliable piece of broadcast equipment for the busy engineer.
Comprehensive commentary unitSuitable for 3 commentators on 1 programme or 3 separate programmesGlitch free redundant Dante network audioTwo copper & two fibre network interfacesMultiple power sources (PoE x 2), Mains & DCBest microphone amplifiers availableePaper displays to make the commentators life easyLocal analogue and AES3 inputs & outputs for extra redundancyIncludes our much revered Referee compressor/ limiterWindows 10 app for remote control & setupNo expense spared to make this the best commentary unit ever
Single Commentators Box For A DANTE Audio Network
Inferno can be used on it’s own when connected to a Dante audio network. Many audio routers, consoles and intercom systems are Dante compatible, and will accept the Inferno link, enabling Glensound grade commentary into the audio network.
Inferno Info Sheet
- Single user Dante commentary box
- System is scalable with multiple commentators as part of a Dante network
- Can connect to any Dante compatible network or to the GSI-DARK88 break out box.
- Single mic/line/48v input with compressor/limiter
- Headphone mixer has 7 inputs supplied from the Dante network, plus the local input (sidetone)
- Browser based remote control of input gain and switching functions
DANTE Audio Network 8 Input, 8 Output Break Out Box
- 8 audio inputs and 8 audio outputs on XLR connections
- Contains network connection to Inferno commentator’s box
- Connection to Dante network for control and configuration
- 1u 19” rackInferno Info Sheet
DANTE Audio Network 16 Input, 16 Output AES & Analogue Break Out Box
The DARK1616 is a versatile break in/ out box for sending/ receiving both analogue and digital (AES3) audio to/ from a network utilizing the Dante audio over IP (AoIP) protocol.
8 off AES3 audio inputs and 8 off AES3 audio outputs16 off Analogue audio inputs and 16 off Analogue audio outputsRedundant Network connectionsNetwork link status GPOsConnection to Dante network for control and configuration1u 19” rackRedundant Power Supply
8 Input Mic Amp for Dante / AES67
The DARK8MAI (Microphone Analogue Input) is a very powerful Dante/ AES67 network audio interface, in a robust stage box/ throw down style. It has a 8 off low noise mic/line inputs which are remotely controlled by a Windows 10 app. The outputs of the microphone amplifiers are transmitted on a fully redundant Dante/ AES67 network interface.
8 Input Microphone AmplifierRedundant Dante Network InterfaceAES67 CompliantCopper & Fibre Network InterfacesPoE PoweredRemote Control Via Windows 10 AppRobust & Portable
Dante & AES67 Network Audio Analogue and AES Interface With Remote Mic Amps
There are 16 digital inputs and 16 digital outputs, available on 8 x AES connections. There are also 16 analogue inputs and 16 analogue outputs, available in parallel to the digital. The analogue and digital outputs are always available, and the inputs work either on AES input priority or can be selected via the control app.
Remote Mic Amps
The analogue inputs are switchable between mic, line and 48v phantom power. These are controllable across the network via the Dark Controller Windows 10 app. This allows remote control by an engineer of the input selection, gain adjust and input on/off control. A meter is also provided for each input on the app, to monitor the input level and help with setting the gain.
Network audio interface with Dante & AES6716 x 16 analogue inputs (mic/line)/outputs16 x 16 digital (8x8 AES) inputs/outputs16 network remote controllable mic ampsRedundant network links and power supplies
2 Circuit 4 Wire Belt Pack With Dante
Complete commentary functionality and 4W in a small belt pack formatMain mic/line input is electronically balanced on XLR with adjustable gain controlInput is switchable from line, mic, or mic + 48v phantom powerLow noise, high headroom mic amplifier48K 24bit A/D converterHeadphone output on 6.35mm jack socketTwo outputs: one for main programme audio, one for talk back circuit, are both on the single RJ45/CAT5 network audio connectionIndependently configurable buttons for both outputs using Config+: latching, momentary or lazyTwo inputs for headphone monitoring from network audio connection, both with adjustable levelHeadphone inputs have left/both/right switchingGlensound intelligent headphone amp provides correct output levels into low or high impedance headphones and can also correctly drive mono earpieces with mono jack plugs.Belt clipPowered via PoE, or via external 12v DCMaximum Dimensions (excluding belt clip): 153 mm x 104 mm x 43mmWeight (excluding battery): 355g
Commentary Unit With Talkback & DANTE Interface
The VITA PLUS is a very powerful Dante network audio interface, in a traditional desktop style. It has a mic/line input and headphone monitoring connection for a single user, and contains two 4 wire circuits. One of these is typically used as an on air channel, and the other as a talkback channel
Complete commentary functionality and 4W in a desktop formatDante AoIP network Input is switchable from line, mic, or mic + 48v phantom powerLow noise, high headroom mic amplifier48K 24bit A/D converterHeadphone output on 6.35mm jack socketTwo outputs: one for main programme audio, one for talk back circuit, are both on the single RJ45/CAT5 network audio connectionIndependently configurable buttons for both outputs using Config+: latching, momentary or lazyTwo inputs for headphone monitoring from network audio connection, both with adjustable levelHeadphone inputs have left/both/right switchingGlensound intelligent headphone amp provides correct output levels into low or high impedance headphones and can also correctly drive mono earpieces with mono jack plugs.Powered via PoE, or internal switch mode PSU
DANTE Studio Headphone Amplifier
Virgil receives 2 x audio circuits from a Dante network and routes one to the left and the other to the right channel of the headphone amplifier. A front panel volume control allows the user to adjust the output volume.
Dante audio inputStereo headphone amplifierCan be used with mono earpiecesUnder desk mountingSmall & robustPowered by PoE6.35 & 3.5mm headphone outputsUp to 96K/ 24 bit audio
4 Circuit 4 Wire With Dante
The GS-FW012 ip is the Dante network audio version of the GS-FW012 4W unit.
There are still four inputs for the top panel loudspeaker or headphone monitoring, each with their own level controls and each being derived from the Dante network.
There are still four talkback outputs each being routed to the Dante network.
Four x 4 wire circuits to/from Dante network plus 1 x local inputInternal or external mic input with individual gain controlsDante network audio, 4 channel input and outputLocal cue input on XLRCue input can be routed to any of the 4 wire outputs4 wire inputs can be routed to their own output (IFB)Latching/ momentary lever keysCan be powered by PoE or Mains
Two User Commentary Unit With Dante
The Express ip was designed to provide a quick and easy solution when it is necessary to provide interfacing for two commentators, with simple facilities, into a Dante network audio network.
This high quality commentary unit is ideal for those looking for cost effective solutions without paying for unwanted features; the Express Box is worthy of investigation.
Two commentary positionsDante network audio interfaceFour external monitor inputs plus side toneTwo common talkback circuitsOperation of talkback buttons configurableMic inputs with selectable 48v phantom power
Software Configuration For Dante Devices
- View all Dante-enabled audio devices and their channels on the network
- View and edit device clock and network settings
- Route audio between devices, and view the state of existing audio routes
- Rename devices and channels using your own friendly names
Dante Controller is available for Windows and Mac OS X.
Download Dante Controller by clicking here
Dante Controller is a free software application developed by Audinate, and is not a Glensound product. For the latest Dante Controller information please visit the Audinate web site by clicking here.